Pipe Repair for Burst, Cracked, and Leaking Lines
Pipe repair is usually a section job, not a whole-house job. We find the exact spot that failed, cut it out, and splice in sound pipe that matches what you have. You get the price before any work starts, and we tell you straight if the pattern points to something bigger.
Manny and his crew did excellent grade A work on the complete remodel of my home, including new sewer and water lines. Trustworthy, thorough, great guy. Highly recommend.
Fix the damaged section, not the whole house
When a supply pipe cracks, bursts, or corrodes through, the rest of the system is often still sound. This is the part of our plumbing services that handles the water lines feeding your fixtures. If you see water but cannot find the source, start with leak detection. If the trouble is the main drain under the house or yard, that is sewer line repair.
Burst pipes
Age, high water pressure, or a hard hit can split a line open. We stop the water, cut out the failed length, and put the run back in service.
Cracked and split pipe
Hairline cracks leak slowly and steadily, often behind a wall. We remove the cracked piece instead of wrapping it and hoping it holds.
Pinhole leaks
Tiny holes from corrosion on copper or galvanized pipe. One pinhole gets a repair. Several on the same run means that run needs replacing.
Failed joints and fittings
Elbows, tees, and threaded joints seep as they age. We rebuild the joint with fresh fittings so it stops weeping.
Freeze and impact damage
An exposed line on a rare frosty night in the inland valleys, or a pipe hit during other work. Same fix, plus insulation or a better route.
Short reroutes
When the damaged line runs under a slab or through a finished room, rerouting a short section can beat tearing up floors.
What kind of pipe do you have?
Pick the one that looks like yours. Each material fails in its own way, and the fix depends on it. You can usually see a stretch of pipe at the water heater, under a sink, or where a line comes out of the wall by a hose bib.
Shiny orange-brown when new, dull brown or green with age. Soldered joints at every fitting.
Pinhole leaks that start on the inside, most often where hard water and fast flow wear the wall thin. Green crust at a joint means it has been weeping.
Cut out the bad section and solder or press in new copper. If pinholes keep showing up on the same run, we talk about replacing that run.
How a damaged pipe gives itself away
Some pipe failures are loud. Most stay quiet for weeks first, soaking into drywall, subfloor, or soil. The sooner a small leak gets fixed, the smaller the repair and the cleanup.
A pipe repair, step by step
What moves the price of a pipe repair
Every job gets an upfront price before any work starts, based on what we find on site. These are the things that make one repair bigger than another.
A repair makes sense when the damage sits in one spot and the pipe around it is sound. When leaks keep showing up in new places, or the house still runs on galvanized steel or polybutylene, repiping usually costs less over time than fixing one leak after another. We will tell you which side of that line you are on.
What our coast and valleys do to pipes
Pipes across Ventura and Santa Barbara Counties wear out in a few predictable ways. Knowing which one you are dealing with changes how we repair it.
Corrosion on exposed metal
Homes near the ocean see copper and steel corrode faster where pipe is exposed: hose bibs, water heater connections, garages, and crawl spaces. We use corrosion-resistant fittings on those runs.
Scale inside the line
A lot of Ventura County runs on hard water. Minerals build up inside the pipe and wear copper thin at elbows where water moves fast, which is where pinholes tend to start.
Steel supply, iron drains
Older neighborhoods in both counties still have galvanized supply lines and cast iron drains. They usually fail at threaded joints and hubs first, so we check those while we are there.
Pipe repair questions we hear most
Have one that is not here? Call and ask. We would rather sort it out on the phone than guess.
Most of the time a pipe repair on the damaged section is all you need, as long as the rest of the line is sound. We look at the pipe on both sides of the failure before we recommend anything. A full repipe only comes up when leaks keep returning in new spots or the material itself is failing.
Close the main water shutoff first. It is usually near where the line enters the house or next to the meter. Then call (805) 232-8380. Our phones are open 24 hours Monday to Friday and 7 AM to 11 PM on weekends.
We repair copper, galvanized steel, PEX, CPVC, polybutylene, and cast iron in homes and commercial buildings. Every pipe repair uses fittings made for that material, and anywhere copper meets steel gets a dielectric union so the joint does not corrode.
Yes. That starts as a leak detection job, then the repair. We locate the source before opening walls, so you are not paying to patch drywall in the wrong place.
Yes. Our shop is in Oxnard, and our crews handle pipe repair across Ventura County and Santa Barbara County, from Thousand Oaks up to Orcutt.
Get the water stopped and the pipe fixed right
Call and a real person answers. Tell us what you see and where, and we will tell you what it likely needs and when a crew can be there. You get the price before any work starts.