Phones open nowMon to Fri: 24 hours · Sat and Sun: 7 AM to 11 PM
4.9 Google RatingFully insuredFamily-run since 2016(805) 232-8380
Plumbing · Repiping

Repiping Services for Homes That Keep Springing Leaks

Our repiping services replace the old supply lines in your home with new PEX or copper, so you stop paying for one leak after another. We plan the routes, open as little wall as we can, and give you the price before any work starts.

Phones open nowMon to Fri: open 24 hoursSat and Sun: 7 AM to 11 PM
Pipe age timelineSupply lines
Before about 1970Galvanized steelRusts inside, flow chokes down
1950s onwardCopperLong life, pinholes with hard water
Late 1970s to mid 1990sPolybutyleneKnown for failing without warning
1980s onwardCPVCTurns brittle with age and heat
2000s onwardPEXFlexible, holds up well
Most common repipe calls
What a repipe is

When repairs stop keeping up

A single leak is a repair. When pipes fail again and again in different rooms, the system is telling you it is worn out. Galvanized steel, polybutylene, and old copper only get worse with time.

A repipe replaces the supply lines from the main shutoff to each fixture, so the problems stop at the source. It is part of our plumbing services. If it really is one bad section, pipe repair is the better spend, and we will say so.

What comes out
Galvanized steel that rusts and chokes off flow
Polybutylene that can fail without warning
Copper worn thin with pinholes
What goes in
PEX: flexible, fewer joints in the walls
Copper: proven on exposed runs
New shutoff valves at the fixtures
Decision helper

Repair or repipe? Answer five questions

Tap yes or no for each one. The more yes answers, the more likely a repipe costs less than the repairs still ahead. It is a starting point, not a diagnosis. We confirm it on site.

01Have you had leaks in two or more different spots in the last few years?
02Is the house plumbed with galvanized steel or polybutylene?
03Does brown or rusty water come out of more than one tap?
04Is pressure weak at several fixtures, not just one?
05Do you see rust, green crust, or flaking on pipe you can reach?
Where you land
Answer the questions to see where you land
0 of 5 answered

Each yes is one more sign the pipes are failing as a system instead of in one spot.

Is it time?

Signs your home needs repiping

One or two of these can wait. Several together usually mean a repipe will cost less than the next round of repairs and the water damage that comes with them.

Rusty or discolored water

Brown or stained water at several taps points to corrosion through the system, not one bad fixture.

Pressure dropping house-wide

When several fixtures go weak at once, the supply lines are narrowing from the inside. If it is only one tap, see low water pressure solutions.

Repeat leaks in new spots

Leaks in a different room every few months are a system wearing out. Not sure where the water is coming from? Start with leak detection.

Visible corrosion

Flaking, dimpling, green crust, or rust on exposed pipe in the garage or crawl space usually means worse inside the walls.

Original galvanized steel

Galvanized pipe rusts from the inside out. In a house that still has it throughout, the problems only grow.

Polybutylene pipe

Gray plastic supply pipe from the late 1970s to the mid 1990s is known for breaking down and failing at the fittings.

How we do it

From the first look to closed walls

A repipe takes planning more than speed. The routes decide how much wall gets opened, so that is where we spend the time up front.

01Look and planWe check the exposed pipe, the water heater connections, and the main shutoff, then map the new routes. You get the plan and the upfront price before anything starts.
02Protect and openFloors and furniture get covered. We cut small, planned access points, mostly in closets, garages, and low on walls, instead of long cuts.
03Run new linesWe work room by room and tie each fixture to the new lines. Water goes off for connections, and we tell you before it does.
04Test and close upThe whole system is pressure-tested before walls close. Access holes get patched and ready for paint, and the work area gets cleaned.
Multi-day project
The crew was knowledgeable and efficient. At the end of each day they cleaned up and recapped the work completed and the plan for the next day. My overall experience was amazing.
Danny LopezGoogle review
Options

PEX or copper: how to choose

Both resist corrosion far better than galvanized steel and will not fail the way polybutylene does. Many repipes use both, PEX inside the walls and copper where pipe is exposed. We help you choose on site.

ComparePEXCopper
How it runsFlexible tubing that bends around corners, so fewer fittings and fewer joints inside walls.Rigid pipe joined at every turn with soldered or pressed fittings.
Wall openingsSnakes through walls and ceilings, which usually means fewer and smaller access holes.Needs straighter paths, so access points can be larger.
Hard waterSmooth inside wall that resists scale and does not pinhole.Holds up well, but hard water and fast flow can wear pinholes over many years.
Exposed runsHas to be kept out of direct sun, so outdoor runs get covered or done in copper.Handles exposed runs in garages and on outside walls well.
BudgetUsually the lower-cost choice for a whole house.Usually costs more in material and labor.
Cost factors

What decides the cost of a repipe

Every repipe gets an upfront price after we see the house, never a guess over the phone. These are the things that set it.

Repeat customer
Manuel and his guys are top notch. Everything from minor repairs to huge repiping jobs. Clean, fast, and very professional. I have used them my last three times and had no issues at all.
John TanakaGoogle review
01Size of the houseMore square footage and more bathrooms mean more pipe and more connections.
02Number of fixturesEvery sink, toilet, tub, shower, and hose bib gets its own tie-in.
03One story or twoSecond floors and finished ceilings take more planning to reach.
04Slab or raised floorA crawl space gives easy routes. A slab house usually means running lines through walls and the attic.
05PEX or copperMaterial and labor differ between the two.
06Patching and permitsHow much wall gets opened and patched, and the permit and inspection the job needs.
Local conditions

Why repipes come up so often here

Three things wear out supply pipe faster across Ventura and Santa Barbara Counties. Most homes we repipe have at least two of them.

Coastal salt airNear the ocean, exposed copper and steel corrode faster at hose bibs, garages, and crawl spaces. We favor PEX inside and protect the metal that stays exposed.
Hard waterWater across much of Ventura County is mineral heavy. It scales up the inside of old steel pipe and wears copper thin, which is why pressure fades and pinholes appear.
Older housingOlder neighborhoods still have original galvanized supply lines. Raised-floor homes with crawl spaces are the easiest to reroute. Slab tract homes take more planning through walls and attics.
Questions

Repiping questions, answered plainly

How long does a whole-house repipe take?

It depends on the size of the house, how many bathrooms it has, and whether we work from a crawl space or through walls over a slab. You get a schedule with the upfront price, and the crew recaps progress at the end of each day.

Can we stay in the house during repiping services?

Most families do. We keep water on to the parts of the house we can and tell you ahead of time when a shutoff is coming. Repiping services are planned around your day, not the other way around.

PEX or copper: which is better?

Both last far longer than galvanized steel or polybutylene. PEX usually means fewer wall openings and a lower cost. Copper handles exposed and outdoor runs well. We recommend one based on your house and walk you through the tradeoffs.

Will you have to open my walls?

Some access is needed to reach pipe inside walls. We plan routes through closets, garages, attics, and crawl spaces to keep openings small, and we patch every one so it is ready for paint.

Do you offer repiping services outside Oxnard?

Yes. Our crews handle repiping services across Ventura County and Santa Barbara County. Homes with original galvanized pipe turn up in older neighborhoods all over both counties.

Done chasing the same leaks?

Find out if it is time to repipe

Call and a real person answers. Tell us how old the house is and what keeps going wrong. We will tell you if a repair will hold or if a repipe makes more sense, and you get the price before any work starts.

Phone hoursOpen now
MondayOpen 24 hours
TuesdayOpen 24 hours
WednesdayOpen 24 hours
ThursdayOpen 24 hours
FridayOpen 24 hours
Saturday7 AM to 11 PM
Sunday7 AM to 11 PM